Skip to main content

SINAMICS S120: Upgrade CU310 to CU310 -2DP_PN


Contents
1.      BACK UP THE EXISTING PROJECT. 2
2.      Upgrade old firmware to new firmware. 2
3.      SWITCH ON THE ELECTRONIC POWER SUPPLY. 3
4.      ESTABLISH THE NETWORK CONNECTION (HARDWARE) 3
5.      CONFIGURE THE NETWORK CONNECTION (SOFTWARE) 3
6.      Download to New Drive. 5

1.    BACK UP THE EXISTING PROJECT

If a project is already stored on the CF card, use STARTER to upload it to the PC/PG and make a backup copy if necessary.

2.    Upgrade old firmware to new firmware

If the firmware has a new device version you must also select the relevant drive unit in the STARTER project tree and then select the required device version by clicking on menu options Target device >> Device version with the right mouse button:








3.    SWITCH ON THE ELECTRONIC POWER SUPPLY

      connect the power supply to the Control Unit (including the 24 V DC supply)

4.    ESTABLISH THE NETWORK CONNECTION (HARDWARE)






5.    CONFIGURE THE NETWORK CONNECTION (SOFTWARE)

   Open the window Network connections by selecting Start >> Settings>> Network Connections on the   Windows PC:


Select the LAN interface which is connected to the Control Unit · Open the properties box for this network connection by clicking on the relevant command in the context menu (right mouse button)


Select Internet Protocol (TCP/IP) in the properties box
Click on the Properties button · Make a note of the existing settings so that you can restore them later! 
· Select the settings as they are shown in Fig. shown and confirm by clicking on the OK button:

6.    Download to New Drive




       
                                     Thank you


Comments

Post a Comment

Popular posts from this blog

SINAMICS G120/ S120: Hardware /Software Change ,Project Upload /Download ,Firmware Upgrade

SINAMICS G120/S120 Hardware /Software Change Project Upload /Download Firmware Upgrade Project Upload/ Download by Starter/ Simotion Scout/BOP The following commissioning tools support the commissioning wizard: STARTER Start drive from V13 SP1 IOP from V1.6 and higher BOP2 If a project is already stored on the CF card, use STARTER to upload it to the PC/PG and make a backup copy if necessary. Upload/Download Procedure with STARTER Inverter → PC/PG To back up the settings with STARTER, proceed as follows: Go online:   Click the "load project to PG/PC" button:   or Target Device>> load project to PG/PC button Wait until STARTER reports that data backup has been completed. Save the project: Go offline:    Click Project >>Archive Button. PC/PG → Inverter Normally this option use when you have changes settings offline or you have old project. To load the settings from the PG to th...
Post a Comment
Read more

SINAMICS S120: Automatic Speed Controller Setting/ Servo Tuning

Automatic Speed Controller Setting/ Servo Tuning ·          In SCOUT/STARTER, press the button     to start the automatic controller setting. ·          Go to SERVO_02->> Commissioning ->> automatic controller setting ·          In TIA Portal/Start drive go to the window "Commissioning" -> "Automatic Servo Tuning". ·          Select Drive Unit (2)->>Select Speed Controller ·          Select drive (5)->>Assume control Priority ·          ON the drive ->>Select perform all step ·          Wait for all step to finish. The determined settings of the speed controller have to be accepted before they ta...
Post a Comment
Read more